Does a mounting magnet not work on your hubs? Then this is the perfect solution! The set consists of: - 1 flat mounting plate with screw end and locknut - 1 bag of 2-component epoxy glue - 1 mixing stick - The mounting plate with screw end is glued to the hub by means of flat mounting. - The bonding takes place by means of a special 2-component epoxy glue. - There is a lock nut on the screw end that ensures that the spinner cannot be tightened too much, which can damage it. Assembly manual: 1 - For maximum strength it is recommended to lightly sand the surface. 2 - Thoroughly clean the surface to be bonded and free of grease. 3 - Mix the two components (resin and hardener 1:1) very well with the supplied mixing sticks 4 - Apply the adhesive evenly on both surfaces 5 - Within 2 minutes, place the spinner in the center of the hub 6 - Make sure the spinner or hub does not move while drying out 7 - let the glue cure for at least 1 hour - Use at your own risk! MC Truckstyling is not responsible for incorrect use or incorrect assembly and any resulting damage. 

-Spinners are not included